How does the sweeper work and what is the sequence of the many buttons on the control panel？

A lot of customers are buyingStreet sweeperAfter that, I saw many buttons on the control panel, and I was confused. I didn't know which button stood for what and where to start。Friends who are used to sprinklers see that the road sweeper is really a first two big, in fact, the operation of the road sweeper is not as difficult as everyone thinks。Now the newly designed and produced vehicles of the road sweeping car manufacturers have simple operation, flexible and convenient use, and a road sweeping car can replace the work of dozens of cleaning workers。The safety of the operator is greatly improved。下面Street sweeperThe manufacturer simplified the basic operation into13Leave it to you。

    1.Water spraying system switch (when cleaning operation, turn on the water spraying switch to reduce dust, during operation, pay attention to the water tank surplus, the pump can not idle without water)

    2.Oil indicator light (oil pressure indicator light, should stop for cooling inspection)

    3.Water temperature table (During operation, the water temperature of the main and secondary engines should not exceed92℃。If the water temperature exceeds92℃Should be stopped for post-cooling inspection)

    4.Charging light

    5.Clean the light switch

    6.Rear door switch

    7.Sub-engine tachometer (sub-engine normal operating speed is1200-1800r/min,High speed operation is strictly prohibited)

    8.Secondary engine ignition start switch

    9.Left front brush lift

    10.Right front brush lift

    11.Sweep switch (sweep rotation to“前”Is to control the four brushes running at the same time, cleaning rotation to“后”Control the operation of the last two sweeps and the front right sweep)

    12.When the box is lifted, the vehicle must be parked smoothly, in the parking brake state, the auxiliary engine should be in idle state, and high-speed rotation is strictly prohibited to avoid damage to the hydraulic system。When lifting the box into the bottom operation, the safety frame must be supported to ensure safe operation。）

    13.Lifting and lowering of the suction cup (Do not reverse when the rear suction cup is on the ground. If you need to reverse, advance the suction cup。During the cleaning operation, if the road surface is seriously damaged or the vehicle wants to pass the speed bump, please raise the rear suction cup and put it down after passing。If the road has a large obstacle or diameter size is greater than100mmWhen garbage, do not force through, so as not to damage the suction)